Table of Contents
Advertisement
4. Camera Operation
The Speed Dome camera will be controlled through the DVR using the arrow keys
etc. However, it is advised to use an external Speed Dome controller, for more
control over the camera.
4.1 Setup Camera Address
1. When the camera has initially been switched on, the OSD will display 485
baudrate, address and protocol (as shown below).
To make the Speed Dome Controller will work with the camera, make sure you
have the baudrate, address and protocol matching on both.
2. Change the camera's protocol by calling Preset 95 and entering the OSD
menu.
MAIN MENU
CAMERA SETUP
FOCUS SETUP
PAN TILT SETUP
PATTERN SETUP
PROTOCOL SETUP
RESET MENU SETUP
EXIT MENU
3. Click on the sub-menu of protocol and use the arrow keys to adjust each
parameter. When finished, navigate to the 'Return' option to save.
10
P27X02
20 02
INITIAL...
PROTOCOL: PELCO-D
ADDRESS: 001
BAUDRATE: 9600BPS
INPUT PELCO COMMAND:
(IRIS OPEN)----OSD MENU
(IRIS CLOSE)----AUTO FOCUS
(GOTO PRESET 95)--OSD MENU
PAN TILT ZOOM
PROTOCOL:
ADDRESS:
BAUDRATE:
RETURN
EXIT MENU
PELCO D
001
9600BPS
Advertisement
Table of Contents
