Page 2
) of either the main unit or the IR remote control. 2. Ensure the volume level of the AVID is set to 0 using the volume controls on the main unit or IR remote control 3. Connect your media player/sound source (eg. CD, DVD, MP3, laptop, etc) from its line level output or headphone output into the AVID’s...
Page 3
• ‘Hard-wired’ Audio Signal Input – A third audio signal may have been ‘hard-wired’ (permanently connected) to the rear connections of your AVID amplifier (for example, if a TV, DVD player or computer is a permanent fixture in the room).
Page 4
AVID. NOTE: If the Switch is set to Lo when a full line level signal is run through the AVID, the volume will be too high, resulting in a distorted sound. Should this occur, the Sensitivity Switch should be immediately set to Hi.