User Instructions Bluetooth Pairing Code (Bluetooth Pairing Code for your AVID3BT can be found on the rear of the amplifier Unit)Please keep for future reference. 07/16...
Page 2
To turn the main unit ON - Short press Switch input, OFF - Press Hold ON/OFF Button. 2. Ensure the volume level of the AVID3BT is set to 0 using the volume controls on the main unit or IR remote control 3.
Page 3
This audio input is wired in parallel with the 3.5mm Jack input on the front of your AVID3BT main unit. Therefore, if the hard-wired source is playing at the same time as the plugged-in source, both signals will give a ‘mixed’...
Page 4
AVID3BT. NOTE: If the Switch is set to Lo when a full line level signal is run through the AVID3BT, the volume will be too high, resulting in a distorted sound. Should this occur, the Sensitivity Switch should be immediately set to Hi.