Step G: Engine Installation - Team Losi 8IGHT 2.0 Assembly And Operation Manual

STEP G-07
•
Adjust the gear mesh between the Clutch Bell and the Spur gear by
sliding the engine mounts in the slots of the chassis. In order to function
properly, the Gears should be as close as possilbe, but still have a small
amount of backlash (space between the Gear teeth).
•
Place a piece of paper between the Clutch Bell gear and Spur gear, slide
the engine sideways until the paper is pinched between the gears and
tighten the engine mount screws. This will give a small amount of space
between the gears.
•
You should be able to rock one gear back and forth slightly while
holding the other one steady. Be sure to check the gear mesh all the way
around the spur gear.
•
Once the engine alignment and gear mesh are correct, tighten all of the
screws. Re-check the gear mesh after all the screws are tight to ensure
the engine mounts did not move.
STEP G-08
STEP G STEP G
Engine Installation
Fuel Tube/Completed Engine Assembly
2
x 1
Body Clip
A8200
Supplied with
pipe
(not included)
1
LOSI-LOK
#8 Countersink
A6351
A9315
Fuel Line
A9316
Fuel Line Clip
30 30 30 30 30 30 30 30 30 30 30 30 30
x 4
8-32 x 1/2"
A6262
x 4
LOSI-LOK