Belkin TuneCast Auto Quick Start Manual page 10

For ipod and iphone

Hide thumbs Also See for TuneCast Auto:

Using the TuneCast Auto

Listening to Mono Recordings

Your TuneCast Auto transmits in stereo, but you can also transmit in mono if needed. We suggest

that you switch to mono transmission only if your car stereo is not receiving a clear signal from the

TuneCast Auto or if you are listening to a mono recording such as an audio book.

To switch to mono transmission, press the "PRO" button until

Pr'~

is shown on the

display. The "PRO" button settings are as follows:

NORMAL-.... pr01 - -.... pro 2 - -..... pro,.

Charging Your iPod or iPhone

Your TuneCast Auto will charge your iPod or iPhone while it is connected to a power outlet

and receiving power. If your iPod or iPhone is not charging, make sure your TuneCast Auto is

correctly connected to the power outlet and that your iPod or iPhone is securely connected

to your TuneCast Auto. The indicator light on the cigarette lighter adapter should be lit.

Note: Some vehicles do not provide power to the power outlet unless the vehicle is in

ignition mode or the engine is running.

Optimizing the Sound Quality of your TuneCast Auto

A variety of car radio and antenna configurations are available and you may optimize the

sound quality in your car based on the location of your TuneCast Auto (for example, placing

the TuneCast Auto on the center console may yield better performance than other locations

within your vehicle).

Using the TuneCast Auto