Troubleshooting - Hayward XStream Filtration Series Owner's Manual

X
Stream™ Filtration Series_____________________________________________________________
Preventative Maintenance (cont.)
Cleaning Cartridge Filter (cont.)
To remove algae, suntan oil, and body oils:
Soak the cartridge element for at least one (1) hour (overnight is most effective) in: 1) a commercial filter
cleaner; OR 2) One (1) cup Tri-Sodium Phosphate (TSP) to five (5) gallons water; OR 3) One (1) cup
dishwasher detergent to five (5) gallons water.
Rinse cartridge element to remove oils and cleaning solution.
To remove calcium carbonate (residue from calcium hypochlorite), iron, or other mineral deposits:
Soak the cartridge element in a solution of one (1) part Muriatic Acid to twenty (20) parts water, until all
bubbling stops.
take extreme care – harmful to eyes, skin, and clothing. Always wear rubber gloves and
eye protection.
will result in a permanent restriction of water flow and cause premature cartridge
failure.
3. Rinse the cartridge element clean and re-assemble filter housing.
Vacuuming
Vacuuming can be performed directly into the filter whenever needed. For fastest results, clean the filter before and
after each vacuuming. For heavy spring clean ups, we recommend using a Hayward SP0727 diverter valve to bypass
the filter and accelerate the clean up process. Consult your local Hayward dealer for a detailed explanation.
Winterization
In areas where sub-freezing temperatures can be expected, the filter should be drained and/or removed from its
operating location and stored indoors. Clean the cartridge element at the end of the pool season by using the Hayward
Jet-action Cleaning Wand (EC2024) or a garden hose with a high-pressure nozzle (See "Cleaning Cartridge Filter"
instructions in this manual).

Troubleshooting

Damaged Cartridge
Element
Algae
WARNING
– Do NOT add water to acid.
WARNING
Do NOT mix chlorine and acid.
–
WARNING
Use a plastic container and
–
CAUTION
– Failure to remove all oils and cleaning solution before acid soaking
Problem
Dirty, clogged, or abused element
Oversized pump
- Produces
excessive
flow rates
and/or
pressures
Very dirty pool water
What to Look for
Dirt, debris, or tear in pleats or folds
Flattened pleats or folds;
Embedded dirt or debris into the
filter material;
Breaking of internal core of the
element;
Breaking or splitting of the end
plates of the element
Algae buildup on the pool walls
Treatment
Clean or replace element
Re-size pump
Frequent cartridge cleaning or
replacement;
Consult professional pool company
for pool chemistry instructions.