Table of Contents
Advertisement
en
Explanation of the symbols on the display panel
Filter needs changing" display
After changing the filter, press the water filter
reset button for approx. 5 seconds to switch
off the display.
Ice maker locked" display
Control panel locked" display
Installation
Installation location
Install the appliance in a dry, well
ventilated room. If installation near
a heat source is unavoidable, use
a suitable insulating plate or observe
the following minimum distances
to a heat source:
Observe the following minimum
distances to heat sources:
- 3 cm to an electric cooker.
- from an oil or solid fuel cooker
30 cm.
The floor on which the appliance is
to be installed must be rigid. If required,
reinforce the floor.
The appliance is very heavy, for empty
weight see the following table.
Basic model
Model with dispenser
Model with home bar
To ensure that the ice maker functions
correctly, the appliance must be
upright. Align the appliance with a spirit
level. To ensure that the doors can
open all the way, observe lateral
minimum distances when installing
the appliance in a corner or recess (see
section on "Appliance dimensions").
Installing and connecting
the appliance
Have a technician install
the appliance and connect it to
the water supply according to
the enclosed installation
instructions.
After installing the appliance, wait at
least ½ hour before switching on
the appliance. During transportation
the oil in the compressor may have
flowed into the refrigeration system.
Downloaded from Fridge-Manual.com Manuals
Before switching on the appliance for
the first time, clean the interior of the
appliance (see "Cleaning the
appliance").
Electrical connection
Do not use an extension lead or a
multi plug socket. This appliance must
be connected to a permanently
installed socket.
The plug to secure the appliance must
be freely accessible. Connect
the appliance to a 220-240 V/50 Hz
AC current via a plug which has been
properly installed. The plug must be
fitted with a 10 A fuse or higher.
If the appliance is to be operated in
a non European country, check on
the rating plate whether the indica
ted voltage and current type corres
pond to the values of your mains
supply. The rating plate is situated
in the bottom left hand side of the
appliance. Any necessary exchan
104 kg
ging of the mains lead should car
ried out by a specialist electrician.
113 kg
Warning!
!
115 kg
Never connect the appliance to
electronic energy saver plugs (e.g.
Ecoboy: Sava Plug) or to power
inverters which convert the direct
current to 230 V alternating current
(e.g. solar equipment, power
supplies on ships).
Observe ambient
temperature and
ventilation
The atmosphere grade is written on
the identification plate. It states
the room temperature within which
the appliance can be operated.
Water" display
Crushed ice" display
Ice cubes" display
Atmosphere grade
SN
N
ST
T
Ventilation
Never cover the ventilation openings in
the base panel. Otherwise,
the refrigerating unit must work harder
and the power consumption is
increased.
Switching on
the appliance
S Insert the mains plug into a socket.
The appliance begins to cool down as
soon as it is connected to the power
supply. When the doors are open,
the interior lights come on.
Note:
The preset temperatures (factory
settings) are reached after approx. 2 to
3 hours. Do not put any food in
the appliance beforehand.
To change the set temperatures > see
Setting the temperature".
Permitted ambient
temperature
+10 °C to 32 °C
+16 °C to 32 °C
+16 °C to 38 °C
+16 °C to 43 °C
Advertisement
Chapters
Table of Contents
