Removing The Rear Cover - JVC MX-G50 Service Manual

Removing the heat sink & AMP board
Prior to performing the following procedure, remove
the metal cover and the CD changer unit.
1. Remove the four screws I attaching the heat sink
cover on the back of the body. Remove the heat sink
cover.
2. Remove the four screws J attaching the heat sink &
AMP board to the rear panel on the back of the body.
3. Remove the two screws K attaching the speaker
terminal to the rear panel on the back of the body.
4. Disconnect the card wire from connector ACW1 and
the harness from connector ACW2 on the AMP
board. (See Fig.11)
5. After moving the heat sink upward, remove the
claws. Then pull out the heat sink & AMP board
inward.
Removing the tuner pack
Prior to performing the following procedure, remove
the metal cover and CD changer unit.
1. Disconnect the card wire from connector CON01 on
the tuner board.
2. Remove the two screws L attaching the tuner pack.

Removing the rear cover

Prior to performing the following procedure, remove
the metal cover, CD changer unit, heat sink & AMP
board and tuner pack.
1. Remove the fore screws M and one screw M' (Only
MX-G50 J / MX-G56 C) attaching the rear panel.
Fig.17
(See Fig.14 and 15)
(See Fig.15 and 16)
(See Fig.17)
M'
Optical out
only
MX-G50 J
MX-G56 C
M
I
Heat sink
cover
I
Rear panel
Fig.14
J
Heat sink
J
Fig.15
Main board
Fig.16
MX-G50/MX-G56
Tuner terminal
L
K
Speaker terminal
CON01
Tuner board
1-9