JVC MX-G50 Service Manual page 7

Removing the CD changer unit
Prior to performing the following procedure, remove
the metal cover.
1. Disconnect the card wire which is attached with
adhesive to the left side of the CD changer unit.
2. Disconnect the card wire from connector CW105 of
the CD servo board on the back of the CD changer
unit.
3. Disconnect the harness from connector RCW6 &
OCW on the inner side of the main board in the
body.
4. Remove the two screws C attaching the CD changer
unit on the back of the body.
5. Remove the two screws D attaching the CD changer
unit on the both side of the body.
6. Draw the CD changer unit upward from behind while
pulling the rear panel outward.
CD changer unit
Rear panel
Fig.10 b
(See Fig.8 to 10)
Adhesive card wire strap
D
Front panel assembly
CD servo board
CW105
Main board
Rear panel
CD changer unit
D
Fig.10 a
MX-G50/MX-G56
CD changer unit
OCW
RCW6
Fig.8
C
Fig.9
Rear panel
1-7