Asus B1M E-Manual page 59

Using Display by AP mode
Using this mode, you can establish a one-to-one connection
between your input device and your LED projector.
1. Connect the Wi-Fi dongle to your LED projector to launch the
Media Center.
NOTE: If the Media Center does not automatically launch, press
then select WiFi>Display via AP mode.
Enable the WiFi connection in your input device. Select ASUS
2.
B1 (default SSID) or the new SSID you configured for the B1M
LED projector.
NOTE: You may also refer to the steps presented onscreen.
3. Type the password on your input device as shown on the LED
projector to enable the AP mode connection.
Open ASUS WiFi Projection on your input device.
4.
Select Projector.
5.
6. Tap the feature you would like to use.
NOTE: The features are subject to change without prior notice due to
sofware updates.
LED projector E-Manual
59