Asus B1M E-Manual page 61

4. Press to launch the onscreen display menu's keyboard.
Refer to the control panel grid when navigating the keyboard to
input the Wi-Fi hotspot's password then press Enter.
NOTE: The B1M LED projector supports WPA/WPA2-enabled devices.
Press OK to start the Wi-Fi connection between the Wi-Fi
5.
hotspot and your LED projector.
6. Repeat the same steps under Using Display by AP mode to
connect input devices to the LED projector.
Using WiFi AP setting
This allows you to change the SSID, Security, and Password settings
when using Display by AP mode.
Using WiFi Client setting
This scans the available WiFi hotspots that you can connect to your
LED projector to enable the Display by Client mode.
LED projector E-Manual
61