1-2-5. Front (R), Front (L/SW), Front (Jack) PC Board
1. Remove the front panel. (Refer to item 1-1-3.)
2. Remove four screws (1), then remove the stay (2).
3. Remove six screws (3), then remove the Front (Center) PC Board (4) and the Front (R) PC Board (5).
5. Remove two screws (6), then remove the Front (Jack) PC board (7).
4. Remove four screws (8), then remove the Front (L/SW) PC board (9).
Front (L) PC board (9)
Note:
• Fasten with the tape, taking care so that the wire does not hang over the tray door.
Front (Jack)
PC board (7)
Screws (8)
Front (SW)
PC board
Front (Center)
PC board (4)
Front panel
Stay
Fasten with
the tape.
Front (R) PC board
Screws (1)
Screws (6)
Screw (3)
Front (R) PC board (5)
Fig. 2-1-11
Operation
Wire
panel door
Fasten with
the tape.
Front (Center)
PC board
Fig. 2-1-12
Stay (2)
Front (Jack)
Front (L)
PC board
PC board