Needle Position Of Zigzag - JUKI HZL-350Z series Service Manual

5-7 Needle position of zigzag

- Choose patterns
- Remove face plate
- Loosen screw (a) of needle bar driving
rod pin. ---(1)
- Adjust needle by turning (b) clockwise /
counter-clockwise.
Clockwise left
Counter-clockwise right
- Make sure needle drops on left / right of
needle hole with even distance to the
edge of needle hole, and then fasten the
screws (a). ---(2)
- After the adjustment of z/z needle
position, re-confirm the needle position
of zigzag.
, zigzag 7 mm.
1
Needle hole
2
14
a
Needle