JessEm Tool 02101A Operating Instructions And Parts Manual page 6

Leveling the Lift to the Table Top Leveling the Lift to the Table Top
The Mast-R-Lift features 8 drilled and tapped Lift features 8 drilled and tapped
holes around the perimeter of the insert plate holes around the perimeter of the insert plate
with adjustable set screws (Fig. 4). Using the
hex wrench included with your lift, turn the set
screws in the clockwise direction to raise the screws in the clockwise direction to raise the
insert plate or turn the set screws in the counter insert plate or turn the set screws in the counter
clockwise direction to lower the insert plate until clockwise direction to lower the insert plate until
the insert plate is level (flush) with the router table the insert plate is level (flush) with the router table
surface. Start at one corner of the insert plate
and work your way around the perimeter of the and work your way around the perimeter of the
insert plate until all set screws have been insert plate until all set screws have been
adjusted properly so that the insert plate does not adjusted properly so that the insert plate does not
rest above or below the table surface. Once the rest above or below the table surface. Once the
insert plate has been leveled properly, please see insert plate has been leveled properly, please
figure 4 for adjusting the insert plate to the table. figure 4 for adjusting the insert plate to the table.
Securing the Mast-R-Lift to the Table
After adjusting the leveling screws and After adjusting the leveling screws and
getting the lift plate level and flush with the getting the lift plate level and flush with the
table top, the Mast-R-Lift can be secured
by inserting a bolt through the top of the through the top of the lift
then screwing the bolt into the
corresponding corner hole in the table corresponding corner hole in the table
opening using a hex key (Fig. 5). This will
secure the lift or plate from moving during secure the lift or plate from moving during
operation. Refer to the router lift or plate operation. Refer to the router lift or plate
manual for more details on leveling the lift
or plate to the table.
Figure 4 Figure 4
). Using the
lift, turn the set
f the insert plate
Lift to the Table
can be secured
). This will
s on leveling the lift
Tab-Loc Insert Rings Loc Insert Rings
The Rout-R-Lift FX comes with one insert Lift FX comes with one insert
ring with a pre with a pre-drilled 1-1/2" diameter
center hole. Additional ring sets are Additional ring sets are
available with different diameter pre-drilled available with different diameter pre
holes and/or no pre-drilled holes for holes and/or no pre
creating your own custom center hole creating your own custom center hole
diameters. See your JessEm distributor for diameters. See your JessEm distributor for
these and other accessories. and other accessories.
1. Place the insert ring into the center
Place the insert ring into the center
hole of the Lift's top plate (Fig. 6). the Lift's top plate (Fig. 6).
2. With the insert wrench provided, insert
With the insert wrench provided, insert
the prongs of the wrench into the prongs of the wrench into the
corresponding holes in the insert ring and holes in the insert ring and
turn the insert ring turn the insert ring counter clockwise to
tighten.
3. Turn the insert wrench clockwise to
Turn the insert wrench clockwise to
loosen and remove the ring. If the insert and remove the ring. If the insert
ring becomes too tight to loosen with hand too tight to loosen with hand
pressure, a tap clockwise on the insert clockwise on the insert
wrench with a block of wrench with a block of wood will loosen it.
Figure 5
Figure 6