Install Muffler - Kohler AEGIS LH630 Service Manual

Section 11
Reassembly
Figure 11-118. Torquing Top Nuts on Upper
Brackets.
9. If a "pulse" style fuel pump is used, install it to the
tapped holes in the #2 side, upper radiator support
bracket and torque the two screws to 6.8-7.3 N·m
(60-65 in. lb.). Connect the outlet line between the
pump and carburetor and the vacuum line to the
crankcase fitting. Secure with the clamps. See
Figure 11-119.
Figure 11-119. Fuel Line and Pump "Pulse" Fuel
Pump.
Install Lower Flywheel Cover,
Rectifier-Regulator and Mounting Plate
1. Install/make sure the small metal spacers are
positioned in the mounting holes of the lower
flywheel cover.
2. Attach the lower flywheel cover to the #2 (oil filter)
side lower radiator support bracket, using two M6
screws and flat washers. Finger tighten only at this
time.
11.32
www.SmallEngineDiscount.com
3. Align the lower flywheel cover with the #1 (starter)
side lower radiator support bracket holes. Position
the rectifier-regulator mounting plate, behind the
cover and install the remaining two screws or nuts
and flat washers. Torque the four fasteners to 9.9
N·m (88 in. lb.). See Figure 11-120.
Figure 11-120. Torquing Lower Screws and
Rectifier-Regulator Mounting.
4. If removed, mount the rectifier-regulator to the plate
with the two screws and attach the connector plug.
See Figure 11-120.

Install Muffler

1. Install new exhaust gaskets and attach the muffler
and mounting hardware. Torque the screws to
9.9 N·m (88 in. lb.).
2. Install the hex. flange nuts to the exhaust studs.
Torque the nuts to 24.4 N·m (216 in. lb.).
Install Oil Filter and Fill Crankcase with Oil
1. Place a new oil filter in a shallow pan with the open
end up. Pour new oil of the proper type through the
threaded center hole. Stop pouring when the oil
reaches the bottom of the threads. Allow a minute
or two for the oil to be absorbed by the filter
material.
2. Put a drop of oil on your fingertip and wipe it on the
rubber gasket.
3. Install the new oil filter to the filter adapter. Turn the
oil filter clockwise until the rubber gasket contacts
the surface, then tighten the filter an additional
2/3-1 turn. See Figure 11-121.
Not For Resale