To Configure Countdown Start Time And Auto-Repeat Settings - Casio 5054 Manual

To configure countdown start time and auto-repeat settings

Start time (minutes)
3. Perform the following operations, depending on which setting currently is selected
on the display.
• While the start time setting is flashing, use D (+) and B (–) to change it.
• While the auto-repeat on/off setting (0N or 0FF) is flashing on the display, press
D to toggle auto-repeat on (0N) and off (0FF).
E-38
1. While the countdown start time is on the display in the
Countdown Timer Mode, hold down A for about three
seconds until the minute setting of the countdown start
time starts to flash. This is the setting mode.
• If the countdown start time is not displayed, use the
procedure under "To use the countdown timer" (page
E-37) to display it.
2. Press C to move the flashing in the sequence shown
below, and select the setting you want to change.
Start Time
(Minutes)
C
Auto-Repeat
On/Off