Table of Contents
Advertisement
2..
IDE.connector.(40-1.pin.PRI_IDE)
The onboard IDE connector is for Ultra DMA 133 / 100 / 66 / 33 signal cable.
There are three connectors on each Ultra DMA 100/66/33 signal cable:
blue, black, and gray. Connect the blue connector to the motherboard's IDE
connector, then select one of the following modes to configure your device(s).
P5QL-M DELUXE/WIFI-AP
P5QL-M DELUXE/WIFI-AP IDE connector
Single device
Two devices
•
Pin 20 on the IDE connector is removed to match the covered hole on the
Ultra DMA cable connector. This prevents incorrect insertion when you
connect the IDE cable.
•
Use the 80-conductor IDE cable for Ultra DMA 133 / 100 / 66 / 33 IDE
devices.
If any device jumper is set as "Cable-Select," ensure that all other device
jumpers have the same setting.
ASUS V-Series P5P43
PRI_IDE
NOTE:Orient the red markings
on the IDE ribbon cable to PIN 1.
Drive.jumper.setting
Cable-Select or Master
Cable-Select
Master
Slave
Mode.of.
Cable.connector
device(s)
-
Master
Slave
Master
Black or gray
Slave
Black
Black
Gray
4-5
Advertisement
Table of Contents
