Jumpers Setup - ASROCK X99 WS-E/10G User Manual

2.5 Jumpers Setup

he illustration shows how jumpers are setup. When the jumper cap is placed on
the pins, the jumper is "Short". If no jumper cap is placed on the pins, the jumper
is "Open". he illustration shows a 3-pin jumper whose pin1 and pin2 are "Short"
when a jumper cap is placed on these 2 pins.
Clear CMOS Jumper
(CLRCMOS1)
(see p.13 or p.16, No. 13)
CLRCMOS1 allows you to clear the data in CMOS. To clear and reset the system
parameters to default setup, please turn of the computer and unplug the power
cord from the power supply. Ater waiting for 15 seconds, use a jumper cap to
short pin2 and pin3 on CLRCMOS1 for 5 seconds. However, please do not clear
the CMOS right ater you update the BIOS. If you need to clear the CMOS when
you just inish updating the BIOS, you must boot up the system irst, and then shut
it down before you do the clear-CMOS action. Please be noted that the password,
date, time, and user default proile will be cleared only if the CMOS battery is
removed.
1. he Clear CMOS Switch has the same function as the Clear CMOS jumper.
2. If you clear the CMOS, the case open may be detected. Please adjust the BIOS option "Clear
Status" to clear the record of previous chassis intrusion status.
SATA DOM Power Jumper
(3-pin SATAPWR1)
(see p.13 or p.16, No. 25)
SATAPWR1 allows you to select the internal voltage source for the SATA DOM
connected on the SATA_0 connector (see p.13 or p.16, No. 24).
Warning: Incorrect setting of this jumper may cause damage to the motherboard
or your SATA DOM.
Default Clear CMOS
SATA DOM
Pin7 Output: +5V
X99 WS-E/10G / X99 WS-E
SATA Power Cable
Pin7 Output: GND
(Default)
31