Comfortcut 450 / Powercut - Gardena EasyCut 400 Operating Instructions Manual

3. Assembly
Assembling the trimmer :
2
1
Fit additional wheel :
5
4. Operation
RISK OF INJURY !
Connecting the trimmer :
8 9
7
1. Push the cover
2
behind
3
2. Push plant guard
until it locks into place.
The additional wheel is available as an optional extra for the
EasyCut 400 / 480. The additional wheel is already fitted on the

ComfortCut 450 / PowerCut 500.

Fit additional wheel :
v Fit additional wheel
guides of the handle holder
until you hear the connection
lock into place on both sides.
z
T
Remove additional wheel :
v Pull both catches
side and remove the additional
4
wheel from the guides of the
handle holder
Fold additional wheel up / down :
4
v Press adjusting buttons
sides, fold additional wheel up / down
and release the adjustment buttons
Risk of injury if the Turbotrimmer does not switch off when
you release the start button.
V Never bypass the safety devices or switches (e.g. by
tying the safety lock to the handle).
1. Insert the loop of the extension cable
9
relief from below through the upper part of the handle
and pull tight.
2. Plug the plug
extension cable
3. Plug the extension cable into a 230 V mains power supply.
0
A
3
into the guide of the cutting head from
until the connection locks into place on both sides.
1
onto the cutting head from the front
4
onto the
5
6
out to the
5
.
z
on both
T
0
of the trimmer into the socket
7
.
2
6
4
4
z
again.
T
7
into the cable strain
8
A
of the
13