Remote Control; Setting The Dip Switches - Hunter ceiling fan Owner's Manual

Remote Control

+ –
switches
Install one (1) 12-Volt, type 23A, MN-21
battery (included) into the transmitter.
Clean the battery contacts and also
those of the device prior to battery
installation. Ensure the battery is
installed correctly with regard to
polarity (+ and -). Please contact your
local battery recycling center for proper
battery disposal information.

Setting the DIP switches:

You will only have to change the DIP switch settings in the
remote if you are using more than one remote controlled fan
in the same area and want to control them separately. You may
want to label your remotes to ensure you do not mix them up.
1. At the circuit breaker or fuse box, turn the power off for
the fan you want to change. Do not turn the power off at the
circuit breaker for the previously installed fan, as you may
inadvertently change the DIP switch code settings for it as well.
2. Slide the cover off the back of the remote and remove the
battery. The battery must be removed when changing DIP
switch settings.
3. Change the DIP switch settings, so that they are different
from the previously installed fan.
4. Replace the battery and cover.
5. At the circuit breaker or fuse box, turn the power back on for
DIP
the fan whose settings you are changing.
6. Within 20 seconds of restoring power, push the 3 (high), 2
(medium), and 1 (low) buttons (in that order) on the remote.
Note: The receiver (built into the fan) has a memory function
that retains the last DIP switch code setting. The setting will not
change in the event of power failure or if the power to the fan is
inadvertently shut off.
M3514-01 • 02/19/13 • © Hunter Fan Company
16
www.HunterFan.com
1.888.830.1326
Switch
Cover
Plate
Removed Rocker-
Tabs Style
Plate
To install the transmitter cradle, remove
the two screws holding the switch
cover plate. Do not remove the cover
plate. Orient the cradle by lining up
the two mounting holes with those on
the cover plate. Insert and tighten the
screws. Do not over tighten. Note: For
rocker-style cover plates, break off the
tabs by pushing outward.