Hitachi DH 24PD3 Technical Data And Service Manual page 8

B. Anchor setting
Anchor setting bar to permit anchor setting operation with the rotary hammer
Anchor setting bar
Anchor setting adapter (SDS-plus shank)
Part name
W-1/4 Anchor setting adapter-A
W-5/16 Anchor setting adapter-A
W-3/8 Anchor setting adapter-A
W-3/8 Anchor setting adapter-A
Internal cone type
Anchor setting bar for manual anchor setting
Anchor setting adapter
Part name
W-1/4 Anchor setting adapter-A
W-5/16 Anchor setting adapter-A
W-3/8 Anchor setting adapter-A
W-1/2 Anchor setting adapter-A
W-5/8 Anchor setting adapter-A
Internal cone type
C. Large hole boring (rotation + hammering)
Center pin, core bit, core bit shank and guide plate
+
(Guide plate) Center pin
(1) Center pin (Do not use bit with outer diameter of 25 mm (31/32") and 29 mm (1-5/32")
Center pin (A) Core bit (outer diameter) 32, 35, 38 mm (1-1/4", 1-3/8", 1-1/2") Code No. 982684
Center pin (B) Core bit (outer diameter) 45, 50 mm (1-25/32", 2")
Overall length Code No.
260 302976
260
302975
160 303621
260
302974
+
Code No.
W-1/4 Anchor setting adapter-B
971794
W-5/16 Anchor setting adapter-B
971795
W-3/8 Anchor setting adapter-B
971796
W-1/2 Anchor setting adapter-B
971797
W-5/8 Anchor setting adapter-B
971798
+ +
Core bit
--- 5 ---
Part name
W-1/4 Anchor setting adapter-B
W-5/16 Anchor setting adapter-B
W-3/8 Anchor setting adapter-B
W-3/8 Anchor setting adapter-B
External cone type
Part name
External cone type
Core bit shank
(SDS-plus shank)
Overall length
Code No.
260
302979
260 302978
160
303622
260 302977
Code No.
971799
971800
971801
971802
971803
Code No. 982685