Hitachi DH 24PD3 Technical Data And Service Manual page 10

F. Drilling hole and driving screw (rotation only)
Drill chuck, chuck adapter (G), special screw and chuck wrench
Special screw
a.
Chuck adapter (G) for SDS-plus shank system
b.
13 mm (1/2") Drill chuck 13VLR (with chuck wrench)
c.
Special screw (M6 left-hand threaded)
(1) Cross-recessed head (Phillips) bit
[Overall length: 70 mm]
(For use with cross-recessed head (Phillips) screw)
Stamped bit No.
Bit No. Code No.
Applicable screw dia. (mm)
No. 2 955654
No. 3 955655
+
13 mm (1/2") Drill chuck
(13VLRB-D)
Chuck wrench
Part name
4 --- 5
6 --- 8
+
Chuck adapter (G)
(SDS-plus shank)
(Note)
If the tool is to be used for loosening screws, open the three jaws of
the drill chuck and securely fix the drill chuck to chuck adapter (G)
with the special screw (a left-hand threaded M6 screw) when
mounting the drill chuck onto chuck adapter (G).
(2) Slotted-head (minus) bit
[Overall length: 50 mm]
(For use with slotted-head (minus) screw)
Tip thickness
Bit tip thickness Code No.
0.8
1
--- 7 ---
Code No.
303623
321814
981122
Applicable screw dia. (mm)
955658
955673
4
5 --- 6