Cleaning, Maintenance And Storage; Protecting The Environment - Black & Decker VH900 Dustbuster Instructions For Use Manual

Warning! The hole in the inflator
adaptor acts as a relief valve to prevent
over-inflating. Do not permanently cover
the hole.
Resetting the motor thermal safeguard
The motor of the appliance is fitted with
a thermal safeguard. This device
automatically switches the appliance off
in case of overheating. If this occurs,
proceed as follows:
Switch the appliance off and remove
N
the plug from the wall socket.
Allow the unit to cool. When the unit
N
has cooled down, check and clean
the filters.
Re-insert the plug in the wall socket
N
and switch the appliance on.
Emptying the container (fig. I & J)
When the container is full it should be
emptied. Always empty the container
into a waste bin outdoors.
Slide the container release button (3)
N
towards the back of the appliance to
release the container door (2).
Open the container door.
N
Empty the container as necessary.
N
Close the container door. Make sure
N
the container door clicks into place.
Cleaning, maintenance and
storage
Warning! Before cleaning and
maintenance, switch the appliance off
and unplug it.
From time to time wipe the
N
appliance with a damp cloth. Do not
use any abrasive or solvent-based
cleaner. Do not immerse the
appliance in water.
Cleaning the motor filter (fig. K & L)
The filter is re-usable and should be
cleaned regularly.
Remove the lid (22).
N
Take the filter (23) out of the
N
appliance.
Shake off excess dust by tapping the
N
filter into a dustbin.
Refit the filter (23) into the appliance.
N
Refit the lid (22). Make sure the lid
N
(22) clicks into place.
Cleaning the exhaust filter (fig. M)
The filter is re-usable and should be
cleaned regularly.
Open the cover (17).
N
Pull the filter (24) from the retaining
N
pin.
Wash the filter in warm, soapy water.
N
Make sure the filter is completely dry.
N
Refit the filter (24).
N
Close the cover.
N
Replacing the filters
The filters must be replaced when
showing signs of wear or damage.
Replacement filters are available from
your Black & Decker dealer.
Remove the old filters as described
N
above.
Fit the new filters as described
N
above.
Storing the appliance (fig. N)
Flip up the power cord retainer (4).
N
Wind the cord around the container
N
and the retainer as shown.
Mains plug replacement
(U.K. & Ireland only)
If a new mains plug needs to be fitted:
Safely dispose of the old plug.
N
Connect the brown lead to the live
N
terminal in the new plug.
Connect the blue lead to the neutral
N
terminal.
Warning! No connection is to be made
to the earth terminal. Follow the fitting
instructions supplied with good quality
plugs. Recommended fuse: 5 A.

Protecting the environment

Separate collection.
This product must not be
disposed of with normal
household waste.
7