Icom IC-F50V SERIES Operating Manual page 10

2
OPERATION
D D Direct code entry
q While in the standby condition, push [TX Code Enter] to enter
the TX code edit mode.
• Code digit for editing blinks.
w Push [TX Code Enter] to select the desired digit to be edited.
• Digit for editing differs according to the setting.
e Set the desired digit using [
r Push [TX Code Enter] to set the digit, then the digit to the right
will blink automatically.
t Repeat e and r to input all allowable digits.
y Push [P0] (Call) or [PTT]* to call.
*PTT call can be made only when PTT call capability is permitted.
NOTE: When no answer back is received, the transceiver re-
peats the call 3 times (default) automatically, and
displayed during each call. However, an error beep sounds
and
"FAILED"
after the calls.
u Push [PTT] to transmit; release to receive.
i Push [P3] (Moni(Audi)) to send the "Clear down" signal.
For your information
When the 'UpDate' setting for the call code is enabled, the set code
is overwritten into the call code memory.
8
]/[
is displayed when no answer back is received
].
is
"WAIT"