Sharp R-380A Service Manual page 10

R-380A
TEST PROCEDURE
POSSIBLE CAUSE
AND
DEFECTIVE PARTS
PROBLEM
CONDITION
Home fuse blows when power
supply cord is plugged into wall
outlet.
FUSE M8A blows when power
supply cord is plugged into wall
outlet.
Display does not show any-
OFF
CONDITION thing when power supply cord
is plugged into wall outlet.
Display does not operate prop-
erly when STOP/CLEAR pad
is touched.
Oven lamp does not light at
door opened. (Display ap-
pears.)
Oven does not start when the
START pad is touched. (Dis-
play appears)
Oven lamp does not light (Dis-
play appears.)
Fan motor does not operate.
(Display appears.)
Turntable motor assembly does
not operate. (Display appears.)
Oven or any electrical parts
does not stop when cooking
time is 0 or STOP/CLEAR pad
is touched.
ON
CONDITION
Oven seems to be operating
but little or no heat is produced
in oven load. (Microwave power
level is set at HIGH)
Oven does not seems to be
operating properly when ME-
DIUM HIGH, MEDIUM, ME-
DIUM LOW or LOW is set.
(Oven operates properly at
HIGH and then the STOP/
CLEAR pad is touched the oven
stops.)
Oven goes into cook cycle but
shuts down before end of cook-
ing cycle.
Oven stops as soon as when
the START pad is touched.
AH sensor does not end during
Sensor Cooking condition.
(Oven does not shut off after a
SENSOR
COOKING cup of water is boiling by sen-
CONDITION
sor cooking.
Oven stops at 16 sec. after
starting.
A B C D E E E E G F H H I K L M N
8
CK = Check / RE = Replace
J O
RE CK CK RE CK CKCK CK CK