Section Ii. Getting Ready To Sew Connecting The Machine To The Power Supply; Controlling Sewing Speed - Janome Hello kitty Instruction Manual

w
q e
r
t
SECTION II. GETTING READY TO SEW
Connecting the Machine to the Power Supply
z Turn off the power switch.
x Insert the machine plug into the machine
socket.
c Insert the power supply plug into the outlet.
v Turn on the power switch to turn on the power
and sewing light.
q Power supply plug
w Power switch
e Outlet
r Machine socket
t Machine plug
CAUTION:
Before connecting the power cord, make
sure the voltage and frequency shown on the
machine conform to your electrical power.
NOTE:
While in operation, always keep your eyes
on the sewing area, and do not touch any
moving parts such as the thread take-up lever,
handwheel or needle.
Always turn off the power switch and unplug
from the power supply:
– when leaving the machine unattended.
– when attaching or removing parts.
– when clearning the machine.
Do not place anything on the foot control,
otherwise the machine will run inadvertently.
Operating Instructions (for the U.S.A and
Canada only)
This appliance has a polarized plug (one blade
wider than the other). To reduce the risk of an
electric shock, this plug is intended to fit in a
polarized outlet only one way. If the plug does
not fit in the outlet, reverse the plug. If it still does
not fit, contact a qualified electrician to install the
proper outlet. Do not modify the plug in any way.
Foot Controller Model KD-1902, YC-482J-EC or
TJC-150 is used with this machine.

Controlling Sewing Speed

Sewing speed can be varied by the foot control.
The harder you press on the foot control, the faster
the machine runs.
4