How To Use The Display Operation Keys - Kenwood VR-510 Instruction Manual

The remote control sends an RF (radio wave) signal to the receiver. For
equipment other than the receiver, an IR (Infrared) signal is sent.
The remote control supplied with this receiver is also capable of controlling
components from a variety of manufacturers once you register the appro-
priate setup codes into the remote control unit.
Refer to "Remote control operation of other components" for details about
the operations available for each component.
SHIFT
MUSIC
AV POWER
CH.
CH.
DIMMER
SOUND
TITLE/GUIDE
RETURN
/PAGE
REC MODE
REC
REPEAT
1
TV SELECT
4
AUDIO
7
INFO.
+10
10
RF REMOTE CONTROL UNIT
1 Display operation 1 key
Use this key to go back to the previous display or initial display.
2 Display operation 2 key
Gets you into and out of the preset code registration mode.
3 Display
The information for setup is displayed.
4 5/∞ keys
Use these keys to select the source or setup code.
5 MOVIE, MUSIC, and TV keys
Use these keys to select the input you want to register.
6 AV POWER
key
Once you have entered the setup code for another component, you can
press this key to turn power to that component on or off. This lets you
confirm that you entered the code properly.
MACRO
MOVIE TV
SYS. POWER
VOL.
VOL.
MUTE
BASS BOOST SUB W.
LISTEN M. THX
MENU
TUNING
BAND
ENTER
OSD
/PAGE
AUTO/MONO
F.SHIFT LEARN
RANDOM INPUT SEL.
2 3
DISPLAY SELECT
5 6
THEME FAVORITE
8 9
EXIT LAST CHANNEL
0 +100
11 12
RC-R0812

How to use the display operation keys

To register the setup code, use the display operation 1 key, display
operation 2 key, or
e
Display operation 1
Display operation 2
The display operation 1 key and display operation 2 key work as the
function key displayed in the display above.
>05.VCR
>06.Cable
Back Enter
When the display goes off
The display goes off automatically when you do not operate for more than
8 seconds. In this case, press the display operation 1 key, display
operation 2 key, or 5/∞ keys.
When you are confused about what's being displayed
Press the display operation 1 key repeatedly until "Menu" appears in the
display.
The display returns to the initial display.
Setting up the system
5/∞
keys.
Display
5/∞
The display operation 1 key
• [Back]
Go back to the previous display.
• [Home]
Go back to the initial display.
• [Clr]
Erase the internal memory.
The display operation 2 key
• [Enter]
Enter the selected item.
• [Menu]
Display the menu.
• [Setup]
Go to the setup display.
• [Exit]
Exit from the current operation.
• [Sel]
Select the item.
21