Names And Functions Of Parts - Kenwood VR-510 Instruction Manual

Names and functions of parts

Speaker indicator
SP
CLIP indicator
C L I P
RDS EON
TP
MUTE indicator
STANDBY
POWER
ON/STANDBY
PHONES
1 POWER (
) key
Use to switch the power ON/STANDBY.
STANDBY indicator
2 MULTI CONTROL knob
Use to control a variety of settings.
3 SET UP key
Use to select the speakers' settings etc.
4 Surround indicators
DTS indicator
Lights when the receiver is in the DTS mode.
DOLBY DIGITAL indicator
Lights when the receiver is in the Dolby Digital
mode.
THX indicator
Lights when the receiver is in the THX mode.
DSP MODE indicator
Lights when the receiver is in the DSP mode.
CS 5.1 indicator
Lights when the receiver is in the CS 5.1 mode.
5 INPUT MODE key
Use to switch between the digital and analog
inputs.
Standby mode
When standby indicator is lit, this receiver is in standby mode and consumes a small amount of current for back-up. This system can be switched on using
remote control.
Frequency display,
Input display,
Preset channel display,
Surround mode display
A B TI.VOL
L C R
MUTE
LFE SW
PTY
SL S SR
TA NEWS
Speaker selection indicators
Input channel indicators
Output channel indicators
AUDIO-VIDEO SURROUND RECEIVER VR-510
MULTI CONTROL
A SPEAKERS B
™ 6 DIMMER key
Use to adjust the brightness of the display.fi
Use to select the REC MODE.
™ 7 MONITOR key
Use to monitor the source that is connected to
™
the MONITOR jack.
8 VOLUME CONTROL knob
9 PHONES jack
¤
Use for headphone listening.
0 SPEAKERS A/B keys
¤
Use to turn the A/B speakers ON/OFF.
! SOUND key
Use to adjust the sound quality and ambience
∞
effects.
@ BAND key
¤
Use to select the broadcast band.
# AUTO
¤
Use to change "TAPE" indication to "MD".¢
Use to select the auto tuning mode.
7 $ LISTEN MODE key
Use to select the listening mode.
AUTO SOUND indicator
Band indicators
DOWNMIX indicator
Display
DOLBY
DTS DIGITAL THX DSP MODE INPUT SELECTOR
SET UP INPUT MODE DIMMER MONITOR
SOUND LISTEN MODE SOURCE DIRECT
BAND AUTO MEMORY
§
§
¢
∞
¢
∞
¶
¶
›
PRO LOGIC
indicator
DIGITAL indicator
S.DIRECT indicator
AUTO indicator
MEMO. indicator
FM AUTO SOUND DIGITAL AUTO
AM PRO LOGIC S.DIRECT MEMO
ST. indicator
ST.
MHz 3 STEREO MONITOR
kHz DOWNMIX DSP TUNED
TUNED indicator
MONITOR indicator
DSP indicator
3 STEREO indicator
STEREO indicator
VOLUME CONTROL
DOWN
S-VIDEO V AV AUX L – AUDIO – R
% MEMORY key
Use to store radio stations in the preset memory.
^ SOURCE DIRECT key
Use to pass the source material direct to the
amplifier.
& INPUT SELECTOR knob
Use to select the input sources.
* AV AUX (S VIDEO, V, AUDIO L/R)
jacks
5
UP
¶
∞
¢
*