Connecting Your Antennas; Connecting The Antenna Wires To The; Antenna Jacks; Using The Am Indoor Loop Antenna (Supplied) - Kenwood SPECTRUM 350 Setting Up

Connecting your antennas

The quality of your FM/AM recep-
tion depends on how well you place
your antennas. So please follow the
instructions carefully.
Connecting the antenna wires
to the antenna jacks
1 Unlock lever
2 Insert wire
3 Lock lever
14.

Using the AM indoor loop antenna (supplied)

Place the antenna as far away as possible from the main system, television,
speaker wires and power cords.
Rotate the antenna until you get the best reception.

Using the FM indoor antenna (supplied)

Use this antenna until you can install an outdoor antenna. When you do,
remove the indoor antenna.
1 Remove the insulation from the wire tip, and twist the wire tightly to get
rid of any loose strands.
2 Connect the end of the wire to the left-most antenna jack on the receiver.
3 Fully extend the antenna, and place it along a wall or bookshelf.
4 Adjust the antenna to find the position that provides the best reception.
5 Attach the looped end to the wall or bookshelf.
ANTENNA
FM75 LOOP ANTENNA
GND
AM
FM300
ANTENNA
FM75 LOOP ANTENNA
GND
AM
FM300