Remote; A Few Tips; Loading And Replacing The Batteries - Kenwood SPECTRUM 350 Setting Up

The remote
You can use your SPECTRUM
system remote for many functions.

A few tips

Depending on temperature,
TUNER buttons
humidity, and other environmen-
TUNER BAND:
tal conditions, the operating
Press to switch
between FM and
range of your remote is approxi-
AM
mately 30' and up to 30° on
P. CALL: Press to
either side of the receiver's
scroll through
remote light sensor.
preset stations
When the operating distance of
your remote begins to get
CD PLAYER
buttons
shorter, replace both alkaline
Press
batteries with new ones.
disc, press again to
pause disc
REMOTE SENSOR
on the receiver
Press
disc
approx.
Press
30 feet
to the next track
30˚ 30˚
Press I
to the previous
track
TAPE A TAPE B
Press DISC to
change to next
TUNER
BAND REC/ARM
disc
P.CALL EQ.
EFFECT M.CALL
CD
I I / II
DISC INPUT SELECTOR
button
Press to scroll through
When you press 2 buttons one
input choices
after the other, press each
button securely for more than 1
POWER button
second each. Press to turn the
system ON or OFF
The remote may malfunction if
direct sunlight or high-frequency
fluorescent light enters the light
sensor. In this case, either move
the audio system, or remove the
light source.
Important:
The batteries that came with this
system are test batteries and may
not last as long as alkaline batteries.
10.
TAPE A TAPE B
TUNER
BAND REC/ARM
P.CALL EQ.
EFFECT M.CALL
CD
I I
to play
DISC
to stop
to skip
I
INPUT MUTE
to skip
VOLUME CONTROL
POWER
REMOTE CONTROL UNIT
RC-SO501
CASSETTE DECK
buttons
Note: These buttons only
work with a Kenwood
cassette deck with system
control connections (not
included with this system)
Press or to play or
reverse tape
Press or to
fast-forward or rewind
tape
Press to stop tape
Press REC/ARM to put
the player into
RECORD/PAUSE mode
/ II
EQUALIZER buttons
For use with an optional
equalizer
Press EFFECT to activate
and deactivate EQ
circuits
Press M. CALL to acti-
vate EQ curves stored in
memory
MUTE button
Press to MUTE the sound,
press again to turn ON
sound
VOLUME buttons
Press or to increase or
decrease volume

Loading and replacing the batteries

If the receiver doesn't respond
when you press a button on the
remote, you need new batteries.
We recommend replacing both
batteries at the same time for longer
battery life.
1 Remove the cover by pressing
down on the ridged area and
sliding it off in the direction of
the arrow.
2 Insert 2 AA-size alkaline batteries
(be sure to pay attention to the
(+) and (-) signs when you're
inserting the batteries).
3 Close the cover.
1
2
3
11.