Table of Contents
Advertisement
Before first-time use
Unpacking
Unpack the device carefully and make sure that all accessories are available:
User manual
Notes for reading the manual
Most functions can be controlled using the remote control.
Preparing the remote control
•
Insert the batteries into the remote control with the correct polarity (+ and -).
•
The battery supplied is intended to test the functions on the remote and may have a limited lifespan.
•
If the remote control's range decreases, replace the old battery with a new one.
•
If the remote control's sensor is exposed to direct sunlight or light from high-frequency fluorescent tubes,
it
may malfunction. If this happens, you should move the system to a different location to avoid such a
malfunction.
Connecting the device
•
Unpack the device carefully and make sure that all the accessories are present.
•
Connect the right and left speaker with their corresponding connections
Speaker Out
(
) at the rear of the device.
•
Insert the power plug firmly into an AC wall outlet.
DAB+ / VHF aerial connection
1. Connect the cable to the socket
2. Look for the place where you can get the best signal.
3. Secure the aerial into position.
•
The aerial that comes with the system is a simple wire antenna. Using an external aerial is recommended to
get a more stable signal. First disconnect your internal aerial in order to connect an outdoor aerial.
•
A DAB reception is not guaranteed when receiving radio station signals over a cable network.
Remote-control
[ANTENNA FM 750]
FM/DAB-aerial
.
LR03/AAA 1.5-volt battery
6
Advertisement
Table of Contents
