Cd Player; Cassette Deck - Kenwood SPECTRUM 350 Setting Up

You can't receive radio stations
Check that the station is tuned in properly.
Check that the TUNER input is selected.
Check that the antenna is connected properly.
You can't receive a preset station by pressing
the corresponding number buttons
Check that the TUNER input is selected.
Check that the preset station is a receivable
frequency.
Check that the preset memory hasn't been cleared
because the power cord was unplugged a long time. If
so, preset the station again.
Interference with reception
Check for interference from electrical appliances. If so,
turn them OFF.
Check for interference from the TV set. If so, turn it
OFF, or move the antenna away from the TV.
Check for interference from automobiles. If so, install
the outdoor antenna away from roads.

CD player

Power light doesn't come on
Check that the power cord is properly plugged into
the AC outlet on the back of the receiver.
Player doesn't play a loaded CD
Check that the CD is loaded right-side up.
Check that the CD isn't cracked or dirty.
There may be condensation on the lens. Leave the
player on for at least 1 hour before using it.
No sound
Check that the CD is loaded properly.
Check that the CD isn't cracked or dirty.
38.
Check that the PLAY mode is active (the PLAY indi-
cator light should be ON).
Check that the audio cables are connected properly.
Skipping (mis-tracking)
Check that the CD isn't cracked or dirty.
Make sure that the player isn't subjected to strong
vibrations.
CD automatically plays when power is turned
on
Remove all CDs before turning the unit OFF. The
player is designed to automatically begin playing when
the power is turned ON.

Cassette deck

No sound when the PLAY button is pressed
Check that the tape isn't blank.
Check that the tape is wound properly in the cassette
case. If not, replace the tape.
Check that the audio cables are connected properly.
Check that the tape heads are clean.
None of the operation buttons work
Make sure that a tape has been inserted into the well.
Make sure the cassette well door is completely
closed.
Make sure that the tape isn't fully wound to the end.
If it is, reinsert the tape facing the other direction.
Check that the tape is wound properly in the cassette
case. If not, replace the tape.
Recordings sound dull
Check that the tape heads are clean.
The recording level may be too high. Set the record-
ing level according to the section 'Setting the record-
ing level' on page 34.
Make sure that Dolby Noise Reduction isn't activated
when playing tapes recorded with no Dolby Noise
Reduction.
Recordings are distorted
The recording level may be too high. Set the record-
ing level according to the section 'Setting the record-
ing level' on page 34.
Pressing the REC and PLAY buttons
simultaneously doesn't start recording
Make sure that the recording-activation tabs have not
been removed from the tape.
Make sure that the cassette well door is completely
closed.
Check that the recording level isn't set to minimum.
Check that the tape isn't fully wound to the end.
Tape noise (hiss) level is high
Make sure that the proper Dolby Noise Reduction is
selected for play.
Make sure that the head is demagnetized properly.
The tape may have been recorded at too low a
recording level. If so, record it again at a higher level.
Sound is 'sour', with unstable pitch
Make sure that the capstans and pinch rollers are
clean.
Make sure that the tape is wound properly in the
cassette case.
None of the functions operate, or the display
shows wrong information
Reset the unit's microcomputer by unplugging the
power cord from the AC outlet and plugging it back
in while holding down the STOP button.
39.