Hardware; Torque Specifications; Fig. 3 Torque Specifications - E-Z-GO MPT 800 Technician's Repair And Service Manual

GENERAL INFORMATION & ROUTINE MAINTENANCE
Read all of Section B and this section before attempting any procedure. Pay particular attention to all Notes, Cautions and Warnings

HARDWARE

Periodically the vehicle should be inspected for loose
fasteners. Fasteners should be tightened in accordance
with the Torque Specifications table (Ref Fig. 3 on page
A-4).

TORQUE SPECIFICATIONS

installed are considered 'wet' and require approximately 80% of the torque required for 'dry' fasteners.
BOLT SIZE 1/4"
Grade 2
(5)
Grade 5
(8)
Grade 8
(8)
BOLT SIZE M4
Class 5.8
(2)
(Grade 2)
5.8
Class 8.8
8.8 (3)
(Grade 5)
Class 10.9
10.9 (4)
(Grade 8)
Ref Tsp 1
Page A-4
ALL TORQUE FIGURES ARE IN FT. LBS. (Nm)
Unless otherwise noted in text, tighten all hardware in accordance with this chart.
This chart specifies 'lubricated' torque figures. Fasteners that are plated or lubricated when
5/16" 3/8"
4 8 15
(11) (20)
6 13 23
(18) (31)
6 18 35
(24) (47)
M5 M6
1 2 4
(3) (6)
2 4 7
(6) (10)
3 6 10
(8) (14)

Fig. 3 Torque Specifications

Repair and Service Manual
Use care when tightening fasteners and refer to the
Technician's Repair and Service Manual for specific
torque values.
Generally, two grades of hardware are used in the vehi-
cle. Grade 5 hardware can be identified by the three
marks on the hexagonal head. Unmarked hardware is
Grade 2.
7/16" 1/2" 9/16"
24 35 55
(33) (47) (75)
35 55 80
(47) (75) (108)
55 80 110
(75) (108) (149)
M8 M10 M12
10 20 35
(14) (27) (47)
18 35 61
(24) (47) (83)
25 49 86
(34) (66) (117)
5/8" 3/4" 7/8"
75 130 125
(102) (176) (169)
110 200 320
(149) (271) (434)
170 280 460
(230) (380) (624)
M14
55
(76.4)
97
(131)
136
(184)
1"
190
(258)
480
(651)
680
(922)