Setting Up Applock - Honeywell MX8 Quick Start Manual

Setting Up AppLock

MX8 devices are shipped to boot in Administration
mode. In this mode, the user has full access to the
device and no password is needed. After the
administrator completes the process below, the MX8
switches to end-user mode and restricts access to only
the specified application(s).
1. Tap Start > Settings > Control Panel >
Administration icon.
2. Assign application(s) on the Application tab
screen.
3. Assign a password on the Security tab screen.
4. Select a view level on the Status tab screen, if
desired.
5. Tap OK.
6. Press the hotkey (Ctrl + Shift + A) sequence to
launch AppLock and lock the configured
application(s).
7. The device is now in end-user mode.