Xte Notice; Ship Speed Notice - Furuno GP-170 Operator's Manual

1. Press the MENU/ESC key to open the main menu.
2. Select [4 Notice Setting] then [1 Arrival/Anchor].
3. Select [2 Anchor]. The anchor notice icon (
hand corner of the display.
4. Press the MENU/ESC key to close the main menu.
To turn off the anchor notice, select [3 Off] at step 3.
6.3

XTE Notice

The XTE (Cross-track error) notice alerts you when your ship is off its intended course
(the line from the start point to the destination waypoint) by the distance specified.
Start point
Intended course
Before setting XTE notice, set the XTL range (see "XTL (Cross-track limit) range" on
page 4-1).
1. Press the MENU/ESC key to open the main menu.
2. Select [4 Notice Setting] then [2 XTE].
3. Select [2 On]. The XTE notice icon (
right-hand corner of the display.
4. Press the MENU/ESC key to close the main menu.
To turn off the XTE notice, select [1 Off] at step 3.
6.4

Ship Speed Notice

The ship speed notice alerts you when your ship's speed is lower or higher than the
speed notice setting or within the range set.
1. Press the MENU/ESC key to open the main menu.
2. Select [4 Notice Setting] then [3 Ship Speed].
3. Select [1 Status].
) appears in gray at the top right-
Destination
waypoint
Notice setting
) appears in gray at the top
6. NOTICES
: Notice zone
6-3