How Do I Adjust The Lcd Display; Using Remote Control Unit Under Low Light; Adjusting The Contrast Of Lcd Display; Adjusting The Brightness Of Receiver - Kenwood KRF-V7773D User Manual

How Do I Adjust the LCD Display?

How Do I Adjust the LCD Display?

Using Remote Control unit under low light

When using Remote Control unit under low light, the back light of the
LCD display can be turned on.
• Press and hold the F.SHIFT key for more than 2 sec-
onds.
The back light is turned on and off every 2 seconds of
holding.
If the is blinked, the back light cannot be turned on
because the batteries are nearly exhausted.

Adjusting the contrast of LCD display

The contrast of the LCD display can be adjusted to improve the visibility.
1. Press the Music key or Movie key to display "Menu".
2. Press the Menu (LCD function key 2) key.
3. Press the Setup (LCD function key 2) key.
4. Press the LCD cursor up/down (
then press the Enter key.
5. Select the desired contrast with the LCD cursor up/down (
key. The previous menu re-appears in about 3 seconds after the above
operation.
42
/8
1 1
/7
1 2 3
4 5 6
7 8 9
+10 0 +100
10 11 12
/ ) key to select "03. Contrast",
/ )
How Do I Adjust the LCD Display?

Adjusting the brightness of receiver

When the ambient light is low, for example in the night, the brightness of
the receiver's display can be dimmed and LED indicators (DTS, 96k fs,
HDCD, DOLBY DIGITAL, MPEG and D.R.I.V.E. only) can be disabled.
Press the F.SHIFT = LISTEN M. (DIMMER)* keys. Each press of the
•
LISTEN M. key switches the brightness as shown below.
1 Display/bright
Indicators/enabled
2 Display/dim
Indicators/enabled
3 Display/dim
Indicators/disabled

Selecting the display mode of receiver front panel

• Press and hold the LISTEN MODE key on the receiver for more than
2 seconds.
The displayed information is switched every 2 seconds of holding the
key.
A: Connected Device
DVD
B: Input Terminal
VIDEO3 :
C: Listen Mode
DOLBY DIGITAL
"Input Type" is displayed only when a selector with digital input is se-
lected.
When the input mode is PHONO, TUNER or AV AUX, the connected
device and listen mode are displayed alternately.
* When an operation is described as [F.SHIFT = LISTEN M. (DIMMER)
key], for example, press the F.SHIFT key and press the next key (the LIS-
TEN M. (DIMMER) key in this case) within 8 seconds.
Input Type
AUTO
Connected Device
DVD
43