Installation - Miele KM 6388 Operating And Installation Instructions

Installation

Preparing the worktop
 Make the worktop cut-out as shown
in the building-in diagram. Observe
the safety distances (see "Safety dis‐
tances").
 Seal the cut surfaces with a suitable
sealant to avoid swelling caused by
moisture. The sealant must be heat-
resistant.
Make sure that the sealant does not
come into contact with the top of the
worktop.
The seal underneath the hob will hold
it securely in the cut-out. Any gap be‐
tween the frame and worktop will re‐
duce with time.
Connecting the mains connection
cable to the appliance
The mains connection cable must
only be connected by a suitably
qualified and competent person.
 Follow the instructions in the wiring
diagram (see "Electrical connection -
Wiring diagram").
Hob with frame or bevelled edge
Installing the hob
 Feed the mains connection cable
down through the cut-out.
 Place the hob centrally in the cut-out.
When doing this, make sure that the
seal under the hob sits flush with the
worktop on all sides. This is impor‐
tant to ensure an effective seal all
round.
Do not use sealant (e.g. silicone).
If the seal does not meet the worktop
correctly on the corners, the corner ra‐
dius (≤ R4) can be carefully scribed to
suit.
 Connect the hob to the mains.
 Check that the hob works.
57