Speakers Set; Input: Video Analog - Yamaha DVR-S150 Service Manual

DVR-S150/NX-P150

5. SPEAKERS SET

The input signal is automatically identified and switched in
the priority order of dts →DOLBY DIGITAL → AAC → PCM
AUDIO → Analog (A/D) according to the signal detection.
The signals output from the DSP block are the same as 1.
DSP THROUGH: 0dB.
The analog switch settings for each sub-menu are as shown
in the table below.
Sub-menu
1 FRNT: SML 0dB
2 CENTER: NONE
3 LFE/B: FRNT
4 Pres Mix: 5cH
LARGE: This mode is used with a speaker with high bass repro-
duction performance (a large unit). Full bandwidth sig-
nals are output.
SMALL: This mode is used with a speaker with low bass repro-
duction performance (a small unit). The signals of 90Hz
or less are mixed into the channel specified by LFE/
BASS.
NONE: This mode is used with no center speaker.
The center content is reduced by 3dB and distributed to
MAIN L/R.

INPUT: VIDEO ANALOG

Sub-menu
1 FRNT: SML 0dB
2 CENTER: NONE
3 LFE/B: FRNT
4 Pres Mix: 5cH
Downloaded From TheatreSystem-Manual.com Manuals
32
FRNT:SML 0dB
CENTER:NONE
LFE/B:MAIN
Pres Mix:5ch
CENTER SP REAR SP
LARGE LARGE
NONE LARGE
SMALL SMALL
LARGE LARGE
Input level Volume
1kHz, Both ch, -20 dBm 86 (-10 dB)
1kHz, Both ch, -20 dBm 86 (-10 dB)
1kHz, Both ch, -20 dBm 86 (-10 dB)
50Hz, Both ch, -20 dBm 86 (-10 dB)
1kHz, Both ch, -20 dBm 86 (-10 dB)
MAIN SP MAIN LEVEL
SMALL 0dB
LARGE 0dB
LARGE 0dB
LARGE 0dB
SPEAKERS OUT (1KHz)
FRONT L/R CENTER SURROUND L/R
+9.0 dBm +9.0 dBm +21.0 dBm
- ∞
+9.0 dBm +21.0 dBm
- ∞
+9.0 dBm +21.0 dBm
- ∞ - ∞
+16.0 dBm +9.0 dBm +21.0 dBm
LFE/BASS
SWFR
BOTH
MAIN
BOTH
SUBWOOFER
(50 Hz)
-3.0 dBm
-0.5 dBm
- ∞
- ∞
+6.5 dBm
-3.0 dBm