Battery Installation And Setup - Taylor 1542 Instruction Manual

BATTERY INSTALLATION AND SETUP

•
Position the remote sensor near the base station.
•
Open the battery compartment at the back of the base station and insert (2) AAA batteries
according to the polarity markings.
•
Replace the battery compartment cover.
•
Press the UP C/F button at the back of the unit to display the temperature in °F or °C.
•
The RF signal icon (located to the left of the outdoor temperature display) will flash for 5 minutes,
indicating that the base station is ready to pick up the RF signal from the remote sensor.
Register the Remote Sensor
•
Open the battery compartment at the back of the remote sensor and slide the channel selector
switch to your desired channel. For the first remote you may select any channel, for additional
remotes select any unused channel.
•
Insert (2) AAA batteries according to the polarity markings. Be sure to install the batteries in the
remote within the time that the RF signal icon is flashing on the base station.
•
Replace the battery compartment cover.
•
If you have registered more than one sensor, press the CHANNEL button to select the remote
channel you want displayed permanently on the base station. Or press CHANNEL until you
observe a circular arrow on the base station LCD display under the channel number. The unit will
then auto-scroll, changing from channel to channel every 5 seconds.
Register a Remote Sensor When the RF Signal Icon is not Showing
To register a remote sensor when the RF signal icon is not showing on the base station LCD:
•
Press and hold the CHANNEL button for 3-4 seconds until the RF signal icon is showing.
•
Install the batteries in the new remote sensor or if the batteries have already been installed, press
either the TX or RESET button, which are located inside the remote battery compartment.
Note:
•
Do not mix old and new batteries.
•
Do not mix alkaline, standard (carbon zinc), or rechargeable (nickel cadmium) batteries.
•
For maximum performance in normal conditions we recommend using good quality alkaline
batteries. When temperatures are below 0°F, alkaline batteries can lose power resulting in a loss
of remote transmission. If you reside in an area that experiences frequent temperatures near or
below 0°F, we recommend using lithium batteries to minimize the loss of transmission.
Locating the Base Station and Remote Sensor
•
Choose a suitable place for the base station and remote outdoor sensor, within the transmission
distance.
•
Place the base unit near a window, but away from direct sunlight or sources of heat or air
conditioning to ensure accurate temperature readings.
•
The remote sensor is water resistant, but not waterproof. Locate the sensor out of direct sunlight,
in an area where it will not be exposed to rain, snow or ice.
•
The location you choose is critical for maximizing the transmission range. The remote sensor is
designed to transmit up to 100 ft. unimpeded. Transmitting through walls, metal doors and metal
framed windows may reduce the transmission range. To optimize the transmission distance, the
remote should be positioned in a location that minimizes these obstructions. Interference from
other sources such as home security systems, wireless doorbells and wireless home entertainment
equipment may interrupt the transmission signal temporarily.
•
In areas of extreme low temperatures, re-locate the remote sensor indoors. Plug the sensor wire
into the remote and route the wire through a nearby window. Be sure to plug in the wire securely.