To Avoid Breakage - Sears 30" GAS SLIDE-IN RANGE Installation Instructions Manual

30" GAS SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
To avoid breakage: Do NOT handle or
manipulate the unit by the cooktop.
1
The counter-top around the cut-out should be flat and leveled (see
hatched area on illustration 1).
2
Before installing the unit, measure the heights of the two (2) cabinet
sides (H1-4), front and back (see illustration 1) from the floor to the
top of the counter.
3
Level the range using the
leveling legs or leveling
device so that the height
from the floor to the
underside of the cooktop
frame is greater than the
tallest cabinet measurement
by at least 1/16" (0,16 cm)
(see illustration 2).
4
Model equipped with leveling
device: Remove and discard the two rear leveling legs, they are only
in place to solidify the unit during the transport.
5
Slide the unit into the cabinet. Make sure the center of the unit is aligned with the center
of the cabinet cut-out.
6
Remove the protective channels on each side of cooktop (if equipped).
7
The metal flange under each side of the cooktop MUST be placed
over the cabinet countertop for proper unit support. The cooktop
should NOT directly touch the countertop (see illustration 2) or
else could cause damage to the cooktop voiding the warranty.
Level the unit if needed.
8
After the
installation,
MAKE SURE
that the unit is
supported by the
leveling legs NOT
by the cooktop.
(Models with Sealed Top Burners)
1 ½" Max.
(3,8 cm Max.)
Shave Raised Edge
to Clear Space
for a Dimension C
(on page 3) Wide
Cooktop.
5
H2
H4
H1
H3
Illustration 1
To successfully
install the
range, the initial
level height
from floor to
underside of
cooktop frame
should be at
least 1/16" (0,16
cm) taller than
cabinet sides
as measured in
step 2.
Illustration 2