System Connections - Kenwood G-EQ300 Instruction Manual

System connections

Make connection as shown below. When connecting the
related system components, refer also to the instruction
8
manuals of the related components.
3 Caution: Do not plug in the power lead until all connec-
tions are completed.
Caution regarding placement
To maintain proper ventilation, be sure to leave a space around the unit (from the largest outer dimensions including projections) equal to, or greater than,
shown below.
Left and right panels: 10 cm, rear panel: 10 cm
AV CONTROL CENTER
(MONITOR)
L
R
REC
Audio cords
Use the numbers 9 0 ! @ on the rear panel of this unit
when connecting it to an AV CONTROL CENTER or
RECEIVER.
Connections are easily completed by using Audio cords
to make connections to the same numbers on the other
component.
1. Connect all cords firmly. If connections are loose there could be loss of sound or noise produced.
2. When plugging and unplugging connection cords, be sure to first remove the power cord from the AC outlet. Plugging/unplugging connection
Notes Notes
cords without removal of the power cord can cause malfunctions or damage on the unit.
3. Do not connect up a power source which is larger than that indicated on the socket at the rear of the unit.
( Except for U.S.A., Canada )
TAPE 2 Connect to the TAPE 2 (MONITOR)
jacks
Set the TAPE 2 (MONITOR ) switch
to the monitoring position.
PLAY
Audio cords
TAPE LINE
SYSTEM
PLAY REC
IN OUT IN OUT CONTROL
L L
R R
Cassette tape deck (optional)
LINE
REC PLAY
IN OUT
L
R
Malfunction of microprocessor
If operation is not possible or erroneous display appears even
though all connections have been made properly, reset the
microprocessor referring to "In case of difficulty".
*CAUTION (For U.K.)
When using the AC outlet epuipped
with this unit, be sure to consult your
dealer for the correspond-ing plug.
SYSTEM
CONTROL
U.K.
Australia
U.S.A., Canada,
China and US military
Other countries
System control cord
This unit
When a cassette deck is connected to the graphic equalizer,do not
connect the system control cord to the cassette deck.
When connecting the audio cords (cords with pin plugs on each
end), insert the white plugs into the L (Left) jacks and red plugs into
the R (Right) jacks.
G-EQ300 (En/K)
*
To wall
AC outlet
AC OUTLET
¢