Operation In Graphic Mode - Kenwood G-EQ300 Instruction Manual

This mode allows to adjust the equalizer curve for each
frequency band provided. The curve created in the param-
eter mode can be fine-adjusted in this mode.

Operation in GRAPHIC mode

1
Select the "graphic equalizer display mode".
2
Select the "EQ.ON" mode.
3
Select the "GRAPHIC" mode.
4
Select the frequency band to be adjusted.
5
Adjust its level.
6
Fine adjustment of each frequency band:
Repeat steps 4 and 5 above.
If the mode is switched from "GRAPHIC" to "PARAMETRIC", the equalizer pattern created in the GRAPHIC mode is cleared.
Note Note
DISPLAY
EQ.EFFECT
GRAPHIC/
PARAMETRIC
FREQUENCY JOG
EQ.LEVEL
Creation of desired equalizer patterns
Each press switches the display modes as follows.
1 Graphic equalizer display mode
2 Spectrum analyzer display mode
3 DEMO(Demonstration) mode
"EQ. ON" lights up.
EQ. ON
Each press switches the display as follows.
1 GRAPHIC
: Mode for adjusting equalizer curves.
2 PARAMETRIC: Mode for creating a curve according
to center frequencies.
2 5 K H Z
1k 1.5k
G-EQ300 (En/K)
"GRAPHIC" lights up.
GRAPHIC
2.5k 3.9k 6.3k
1 7