Creation Of Desired Equalizer Patterns; Operation In Parametric Mode - Kenwood G-EQ300 Instruction Manual

Creation of desired equalizer patterns

Equalizer curves can be created by setting up to 3 center
frequencies and the equalizing levels for them.
The inclination of each curve can be selected between WIDE
(gentle slope) and NARROW (steep).

Operation in PARAMETRIC mode

1
Select the "graphic equalizer display mode".
2
Select the "EQ.ON" mode.
3
Select the "PARAMETRIC" mode
4
Select the key to store the center frequency.
(Continued on next page)
DISPLAY
EQ.EFFECT
GRAPHIC/
PARAMETRIC
F1
F2 F3
: Keys and control used in the operations described on this page.
Each press switches the display modes as follows.
1 Graphic equalizer display mode
2 Spectrum analyzer display mode
3 DEMO(Demonstration) mode
"EQ. ON" Lights up.
EQ. ON
Each press switches the display as follows.
1 GRAPHIC
: Mode for adjusting equalizer curves.
2 PARAMETRIC : Mode for creating a curve according
to center frequencies.
"PARAMETRIC" Lights up.
"F1" Lights up.
G-EQ300 (En/K)
PARAMETRIC
PARAMETRIC
F1
1 5