Table of Contents
Advertisement
■ WDR Pro : When enabled, you can select the strength of the WDR function. The Low, Medium,
High options correspond to the level of contrast between the overly-lit area and the shaded areas�
For example, the High option applies to a high contrast scenario� Note that when the exposure
time is set to longer than 1/60 second, the WDR function will be disabled�
You can click Restore to recall the original settings without incorporating the changes� When
completed with the settings on this page, click Save to enable the settings�
If you want to configure another sensor setting for day/night/schedule mode, please click Profile to
open the Profile of exposure settings page as shown below.
Activated period: Select the mode this profile to apply to: Day mode, Night mode, or Schedule
mode� Please manually enter a range of time if you choose Schedule mode� Then check Save to
take effect�
Please follow the steps below to setup a profile:
1� Check Enable this profile�
2. Select the applied mode: Day mode, Night mode,
or Schedule mode� Please manually enter a range
of time if you choose Schedule mode�
3. Configure Exposure control settings in the folowing
columns� Please refer to previous dicussions for
detailed information�
4� Click Save to enable the setting and click Close to
exit the page�
VIVOTEK
User's Manual - 63
Advertisement
Table of Contents
