Power Up / Idle Mode - Schwinn 430 Assembly And Owner's Manual

To release the Incline Assembly:
Do not adjust the workout angle when on the machine.
1. Grasp the Incline Adjustment Handle and push the Incline Release Button with the
palm of your hand. Be prepared to support the weight of the raised parts of the
machine.
When released, the Incline Assembly may fully disengage. Make sure that you are
able to support the weight of the raised parts of the machine safely.
Note: The Incline Handle may need to be slightly lifted to disengage the Incline Assembly.
2. Lower to the desired height.
In order to avoid possible serious injury when lowering the Rails, be careful to avoid fingers or hands being caught or
pinched.
4. Release the Incline Release Button.
5. Push down on the Pedals to be sure the Rails are secured by the Incline Assembly.
Note: Do not step onto the machine until you know the Incline Assembly is secure.
Power-Up / Idle Mode
The Console will enter Power-Up / Idle Mode if it is plugged into a power source, any button is pushed, or if it receives a signal
from the RPM sensor as a result of pedaling the machine.
Auto Shut-Off (Sleep Mode)
If the Console does not receive any input in approximately 5 minutes, it will automatically shut off. The LCD display is off while
in Sleep Mode.
Note: The Console does not have an On/Off switch.
Initial Setup
During the first power-up, the Console should be setup with the date, time and your preferred measurement units.
1. Date: Push the Increase/Decrease buttons to adjust the currently active value (flashing). Push the Left/Right buttons to
change which segment is the currently active value (month / day / year).
2. Push OK to set.
3. Time: Push the Increase/Decrease buttons to adjust the currently active value (flashing). Push the Left/Right buttons to
change which segment is the currently active value (hour / minute / AM or PM).
4. Push OK to set.
5. Units of Measurement: Push the Increase/Decrease buttons to adjust between "MILES" (Imperial English) or "KM"
(metric).
6. Push OK to set. The Console goes back to the Power-Up / Idle Mode screen.
Note: To adjust these selections, consult the "Console Set-Up Mode" section.
29