Miele KFN 37432 iD Operating And Installation Instructions page 58

Problem solving guide
Messages in the display
Problem
The Alarm symbol
; flashes in the
display together with
the sensor for one of
the sections.
The alarm sounds
and the mains
connection symbol
t appears in the
display.
The display will
show the warmest
temperature
recorded in the
freezer section
during an
interruption to the
power supply or a
power cut.
58
Possible cause
The temperature in the
section concerned has
risen higher or fallen lower
than the temperature that
has been set. This could be
due to:
– the door being opened
too frequently.
– a large amount of fresh
frood being put in at once
for freezing without
switching on the Super
freeze function.
– a lengthy interruption to
the power supply.
The temperature has risen
too high at some point
during the last couple of
hours or days because of
an interruption to the power
supply a power cut.
When power is restored,
the appliance will start
operating again at the last
temperature setting
selected.
Remedy
^ Rectify the cause of the
alarm. The alarm symbol ;
goes out and the sensor for
the section concerned
lights up constantly. The
audible alarm stops.
Depending on the
temperature in the freezer
section, you should check
the condition of the food. If
food has defrosted or
started to defrost, check
that it is still safe to use, and
if so, use it as quickly as
possible. Defrosted food
may only be re-frozen after
it has been cooked.
^ Press the alarm off sensor.
The warmest recorded
temperature will go out in
the display. The display will
then revert to showing the
current temperature in the
freezer section.
^ Depending on the
temperature in the freezer,
you should check the
condition of the food. If
food has defrosted or
started to defrost, check
that it is still safe to use,
and if so, use it as quickly
as possible. Defrosted
food may only be re-frozen
after it has been cooked.