Quick Start Owner's Manual (English) - Numark X2 Quick Start Owner's Manual

Quick Start Owner's Manual (ENGLISH)

1. Make sure all items listed on the front of
this guide were in the box.
2. READ SAFETY INSTRUCTION BOOKLET
BEFORE USING THE PRODUCT.
3. Assemble unit following the Quick
Assembly Instructions.
4. Study this setup diagram.
5. Place the unit in an appropriate position for
operation.
6. Make sure all devices are turned off and all
faders and gain knobs are set to "zero"
7. Connect all stereo input sources as
indicated in the diagram, your microphone,
and headphones
8. Connect the stereo outputs to power
amplifier(s), tape decks, and/or other audio
sources.
Quick Assembly Instructions
1. Notice the locking pins shown. BE SURE THAT TURNTABLE IS NOT PLUGGED IN.
2. Match the inner motor to Figure 2.
3. Carefully place platter with holes aligned to base as shown
9. Plug all devices into AC power.
10. Switch everything on in the following order.
•
•
•
11. When turning off, always reverse this
operation by,
•
•
•
12. Go to
registration.
More information about this product may be
found at
Connections
TO MIXER LINE INPUT
TO MIXER LINE INPUT
TO FADER START COMPATIBLE DEVICE
TO RELAY COMPATIBLE DEVICE
2
audio sources (i.e. turntables or CD
players)
mixer
last, any amplifiers or output devices
turning off amplifiers
mixer
last, any audio sources
http://www.numark.com
http://www.numark.com
TO MIXER PHONO INPUT
TO POWER OUTLET
for product