Waeco MagicSafe MS650 Installation And Operating Manual page 50

MS-650.qxd 13/08/03
Check how your vehicle's central locking system works.
Connect the central locking system using the circuit diagrams
(see ✎ E 3 to I 1). Wires that are not connected need to be
insulated.
In the case of some vehicles, e.g. Mercedes, it is possible that the
actuation time of 0.6 sec. is not sufficient to fully operate the central
locking system.
In these cases, set the actuation time to 3.5 secs. by reprogramming the
software, (see Programming) .
Normally the unit is set to 0.6 secs.
Circuit diagram No. 1 (see ✎ E 3)
Caution! The illustrated wiring diagram is only valid for cars
without a servo motor in the driver's door or for vacuum central
locking without electric connection.
Servo motor for driver's door WAECO Art.-no. ML-11
Circuit diagram No. 2 (see ✎ F 1) Two cables switching from negative
to + 12 V
Circuit diagram No. 3 (see ✎ F 2) Two + 12 V pulse control cables
Circuit diagram No. 4 (see ✎ G 1) Two minus pulse control cables
Circuit diagram No. 5 (see ✎ G 2) One open and negative pulse
control cable
12:58
Connection to the central locking
Circuit diagram
Page 50
50