Pt 8251, 8331 Cop; Control Panel Pt 8251, 8331 Profitronic B Cop (Coin Operation); Selecting A Temperature; At The End Of The Drying Duration - Miele PT 8251 + COP Operating Instructions Manual

Control panel PT 8251, 8331 Profitronic B COP (Coin Operation)

3
1 Segment display - Time
4 Venting system fault indicator
Time selection can be controlled by a C 4065 coin control unit or other type of payment system.
^ Press the mains On/Off switch s
^ Load the drum and close the door.

Selecting a temperature

High
Medium
Low
Cold
^ Press the temperature selection button and select
the required drying temperature -
Cold, Low, Medium, High.
The corresponding LED will light up.
Cold For airing fabrics
Low Delicates, synthetic fibre and rayon fabrics
Medium Minimum iron, synthetic and mixed fibre
fabrics
High Cottons, cotton and linen fabrics
^ Insert coins or tokens.
The START/STOP button will start flashing.
^ Press the START/STOP button.
The temperature can only be altered in the first 3
minutes* after the programme has started.
*(can be changed in Service mode)
1 2
4 5 6
2 Programme sequence display
5 Fluff filter fault indicator
3 Temperature selection button
6 START/STOP button

At the end of the drying duration

!
Drying
L
Cooling down
O
Programme finished / Anti-crease
At the end of the drying duration the "Drying" and
"Programme finished" programme sequence stage
symbols will flash. "Cooling down" will light up and the
cooling down phase will begin.
!
Drying
L
Cooling down
O
Programme finished / Anti-crease
At the end of the cooling down phase all three
programme stage symbols will flash and the buzzer
will sound.
^ Remove the laundry.
Interrupt the programme by opening the drum door
or the fluff filter compartment flap:
^ Continue the programme by closing the drum
door/fluff filter compartment flap and pressing the
START/STOP button.
Short operating instructions which can be used as
a wall chart are supplied with the dryer.

PT 8251, 8331 COP

7
7 On/Off switch
15