Preparation; Installing The Nicd Battery Pack; Charging The Nicd Battery Pack - Kenwood TH-D7A Instruction Manual

1

INSTALLING THE NiCd BATTERY PACK

2
1 Position the two grooves on the inside bottom corners
3
of the battery pack over the corresponding guides on
4
the back of the transceiver.
5
6
7
8
Guide
9
2 Slide the battery pack along the back of the
10
transceiver until the release latch on the base of the
11
transceiver locks the battery pack in place.
12
13
14
15
16
17
3 To remove the battery pack, push up the release
18
latch, then slide the battery pack back.
19
20
Release latch
21
22
23
2

PREPARATION

CHARGING THE NiCd BATTERY PACK

After installing the NiCd battery pack, charge the battery
pack. The battery pack is provided uncharged.
1 Confirm that the transceiver power is OFF.
• While charging the battery pack, leave the transceiver
power OFF.
2 Insert the DC plug from the charger into the DC IN
jack on the transceiver.
3 Insert the charger AC plug into an AC wall outlet.
• Charging starts and will take approximately 16 hours for
PB-38 or 15 hours for PB-39.
4 After 16 hours (PB-38) or 15 hours (PB-39), remove
the charger DC plug from the transceiver DC IN jack.
5 Remove the charger AC plug from the AC wall outlet.
Exceeding the specified charge period shortens the useful life of
the NiCd battery pack.
The provided charger is designed to charge only the provided
PB-38 or PB-39 NiCd battery pack. Charging other models
of battery packs will damage the charger and battery pack.
DC IN jack